Toilet Repair in Fort Lauderdale

Usually a faulty flapper, fill valve, or flush valve. These are inexpensive repairs that stop water waste and save money on your water bill.

A running toilet can waste 200+ gallons per day, adding $50-100+ to your monthly water bill. Fixing it quickly pays for itself.

Toilets made before 1994 use 3.5-7 gallons per flush. Modern toilets use 1.28 or less. If repairs exceed $150-200, replacement often makes more sense.

Yes. We regularly work in high-rise condominiums in Fort Lauderdale. Most individual unit toilet repairs only require shutting off the unit's supply valve and do not affect other residents. For issues that require building stack access, we coordinate with building management. We are familiar with the access and logistics requirements in Fort Lauderdale's major condo buildings.

A hissing sound after flushing — or continuously — is almost always the fill valve failing to shut off properly. Water continues flowing into the tank past the fill level, creating the hissing sound as it runs into the overflow tube. It is a straightforward fill valve replacement in most cases and should be addressed promptly to avoid water waste.

Cast iron flanges can be repaired in many cases using repair rings that clamp over or bolt through the existing flange. If the cast iron is cracked or has dropped below the floor level, a more involved repair or full flange replacement is needed. We inspect the flange condition whenever we remove a toilet and recommend the appropriate repair approach for your specific situation.

A toilet running constantly or cycling on its own overnight is wasting water and driving up your bill. The cause is almost always a leaking flapper that lets water drain from the tank slowly, triggering the fill valve to refill periodically. A flapper replacement is typically a quick, low-cost fix. Call us and we can usually address it the same day.

Intermittent running — where the toilet refills on its own every few minutes without being flushed — is caused by a leaking flapper. Water slowly seeps from the tank into the bowl, and when the tank level drops low enough, the fill valve activates to refill it. The flapper is degraded and not sealing fully against the flush valve seat. A flapper replacement fixes it in most cases.

Flush valve replacement in a condo only requires shutting off the individual toilet's supply valve — it does not require a building shutoff. We drain the tank, remove the old flush valve assembly from the bottom of the tank, and install a new one. The process takes under an hour in most cases and restores full, reliable flush performance. We carry common flush valve assemblies for standard residential toilets.